How to Replace Door Glass on a 1994 Blazer

| |
How to Replace Door Glass on a 1994 Blazer

Wayward balls, rocks, gravel can all damage window glass. This is especially true for vehicle windows. Replacing door window glass in a 1994 Chevrolet Blazer is not as hard as it sounds. Window glass does not require the specialty tools windshields require. Everyday household tools and a helper are all you need for this repair.

Instructions

    1

    Lower the window to be replaced on the Blazer all the way down. Disconnect the negative cable from the battery.

    2

    Pry off the cover on each side of the pull strap with a small flathead screwdriver. Remove the screws with a Phillips screwdriver.

    3

    Remove the screw in the Blazers armrest with a Phillips screwdriver.

    4

    Remove the window crank for manual windows. Pry off the control switch panel with a flathead screwdriver for automatic windows.

    5

    Insert a large flathead screwdriver between the door panel and trim to disengage the retaining clips. Slide the screwdriver around the entire trim until all retaining clips are disengaged.

    6

    Remove the trim panel from the Blazer. Peel the plastic water shield back.

    7

    Remove the retaining screws with a Phillips screwdriver. Pull the door module back. Disconnect the door lock and handle rods. Disconnect the electrical connector.

    8

    Remove the two glass run channel bolts, on the door by the hinges, with a ratchet and socket. Pull the channel away from the glass.

    9

    Tilt the door module and window glass assembly. Lower the module and assembly out of the bottom of the door.

    10

    Bend the tab down on the window run channel. Slide the window glass out.

    11

    Slide the new glass into the window run channel. Raise the door module and assembly into the bottom of the door.

    12

    Push the window channel toward the glass. Install the channel bolts with a ratchet and socket.

    13

    Connect the electrical connector. Connect the door lock and handle rods.

    14

    Push the door module in. Install the retaining screws with a Phillips screwdriver.

    15

    Place the trim panel in position. Press the door panel into place until the clips engage. Install the armrest screw with a Phillips screwdriver. Install the manual crank or control panel.

    16

    Reconnect the negative battery cable.

Related Posts by Categories

0 comments:

Post a Comment